Coyote Point Systems Equalizer Especificações descarregar pdf (Página 112)

100

101

Network Configuration

Destination IP Address - The IP address for the host or subnet. For IPv4, specified as a Classless

Internet Domain Routing (CIDR) address (e.g. 192.168.1.0/24). For IPv6, specified using IPv6 subnet

notation.

Gateway - The IP address of the gateway used to reach the host or subnet.

l Prefer - Enabling this flag allows you to specify the “preferred” route to be used for any matching destination

- even if the destination address is on a subnet that is defined on Equalizer. One Prefer flag is allowed for

each subnet is allowed at this time, however, this can be enabled on as many static routes as necessary.

To modify a static route, highlight the route in the table and click the Modify icon . Change the parameters and

click commit.

To delete a static route, highlight the route in the table and click the Delete icon .

Subnet Static Routes (CLI)

Static routes are specified in the subnet context (See "VLAN and Subnet Commands" on page 186).

To display the static route for a subnet, use the show command:

eqcli > show vlan vlan_name subnet subnet_name

To add a static route from the global context, enter:

eqcli > vlan vlan_name subnet subnet_name route IP_addr gateway

The parameters are explained as follows:

vlan_name - The name of the VLAN.

subnet_name - The name of the subnet.

IP_addr - The IP address for the host or subnet. For IPv4, specified as a Classless Internet Domain

Routing (CIDR) address (e.g. 192.168.1.0/24). For IPv6, specified using IPv6 subnet notation.

gateway - The IP address of the gateway used to reach the host or subnet.

Note - the “prefer” flag, which allows you to specify the “preferred” route to be used for any matching destination - even if the destination

addressis on a subnet that is defined on Equalizer- is not available using eqcli at this time.

To modify a static route, specify the same IP_Addr in the above command line.

To delete a static route, use the no form of the route command:

eqcli > no vlan vlan_name subnet subnet_name route IP_addr gateway

112

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 593 594

Comentários a estes Manuais

Sem comentários

Coyote Point Systems Equalizer Especificações Página 112

Comentários a estes Manuais

Manuais e produtos relacionados com Equalizadores Coyote Point Systems Equalizer