Coyote Point Systems Equalizer Especificações descarregar pdf (Página 15)

Deploying Equalizer with MS Terminal Services

Deployment Guide

6. In the Session directory server name box, type the DNS name or IP

address of the domain server where the Terminal Services Session

Directory service is running. Note that the server name must be a valid

server name, and you cannot leave this box empty. (Also, the server

name cannot be localhost or 127.0.0.1.)

7. Verify that the IP Address redirection check box is enabled.

8. Click OK to save your settings.

Configuration Example 3:

MSTS/Equalizer Deployment with Token Redirect Session Services

Overview

While IP redirection is the preferred setting for Session Broker, Equalizer can

also work with a Session Broker that uses token redirection; the setup must be

the same as Configuration Example 2 with the following exceptions:

The sticky time on the cluster must be set to a non-zero value, and the session

time on the MSTS servers must be set to the same value – as in Configuration

Example 1. This means that the Token Redirection configuration suffers from

the disadvantages outlined for Configuration Example 1 -- i.e., the client

connection may end up getting load balanced only on initial connection, and

will be ‘stuck’ to a server until the sticky time expires.

Equalizer makes a TCP connection to the server on the server port (3389) to

determine if it is up, but by default does not validate that an RDP connection

can be made.

This can lead to a situation where Equalizer thinks a server with a sticky record

is up, but if the server is not able to make an RDP connection (e.g., the server

is up but for some reason can’t make an RDP connection), the client essentially

gets 'stuck' on the server until the server can connect, until the sticky/session

timers expire, or until the session is manually deleted from the Terminal

Manager on the appropriate server.

To eliminate this possibility, the terminal servers should be set to End instead

of Disconnect broken sessions, and an Equalizer server agent can be deployed to

ensure that RDP is working in order for a server to be considered up.

Deployment Steps

The steps required to set up the example configuration involve defining the

Equalizer cluster and the associated parameters, defining the servers and server

settings, and deploying the server agent on each MSTS server:

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21 22

Sem comentários

Coyote Point Systems Equalizer Especificações Página 15